Epson Stylus Photo R220 - Paper Support Assy.;Housing (Left;Right);Stacker Assy. Removal

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 46
2.3.1 Paper Support Assy./Housing (left/right)/Stacker
Assy. removal
 External View
Figure 2-2. Paper Support Assy./Housing (left/right) removal
 Parts/Units which should be removed before removing the Paper Support
Assy./Housing (left/right)/Stacker Assy.
None
 Disassembly Procedure
 Paper Support Assy. Removal
1. Release the two dowels that secure the Paper Support Assy. to the Frame ASF
and remove the assy.
 Housing (left/right) Removal
1. Remove the two screws ( , ) that secure the Housing (left/right).
2. Release the left and right tabs ( ) by pushing them toward the front side of
the printer with a flat-blade screwdriver or similar tool.
3. Release right tab ( ) by inserting a flat-blade screwdriver between the
Housing, Lower and the Housing, Right. (Release the left tab ( ) by pulling
the bottom of the Housing, Left downward.)
4. Unlock the Carriage Lock with tweezers or similar tool, and move the
Carriage Unit to the center.
5. Insert your hand inside the Housing (left/right) to release the tabs ( , ).
Left Bottom of the Printer
4
Right Bottom of the Printer
Rear of the Printer
Paper Support Assy.
C.B.P. 3x8 (4-6kgf.cm)
3
3
Housing, Left
6
5
5
6
Housing, Right
1
2
Dowel that secures the
Paper Support Assy.
4
Carriage Lock
C.B.P. 3x8 (4-6kgf.cm)
1 2
3
4
4
5 6