Epson Stylus Photo R220 - Holder, Shaft Assy.;Ld Roller Removal

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 59
2.3.8 Holder, Shaft Assy./LD Roller Removal
 External View
Figure 2-16. Holder, Shaft Assy. Removal (1)
 Parts/Units which should be removed before removing the Holder, Shaft
Assy. and LD Roller.
Paper Support Assy./Housing (left/right)/Housing, Frame/ASF Assy.
 Disassembly Procedure
 Holder, Shaft Assy. Removal
1. Disconnect the following connector cables from the Main Board Assy.
CN5: CR Motor cable
CN9: PE Sensor cable
CN7: Print Head FFC
CN8: Print Head FFC
CN15: CSIC/CR Encoder /PW Sensor FFC
2. Release the CR Motor connector cable from the tabs of the Holder, Shaft
Assy.
3. Remove the two screws that secure the Holder, Shaft Assy. to the Frame,
Main.
4. Remove the Shield Plate, FFC from the Frame, Main. Then Release the Cable,
Head from the two tabs of the Holder, Shaft Assy., and pull out it together
with the Shield Plate, FFC frontward of the printer.
5. There are seven tabs and one dowel that secure the Holder, Shaft Assy.
First release the two tabs ( ). And slightly lift the Holder, Shaft Assy.
releasing the dowel ( ), then release the other five tabs.
6. Slide the Holder, Shaft Assy. rightward viewed from the rear of the printer,
remove the upper side of the assy. toward you and then remove it obliquely
upward.
Right Side of the Printer
Cable, Head
Shield Plate, FFC
Tabs
Tabs
Tabs Tabs
1
1
PE Sensor Flag
Dowel
CN5, CN9
CN7, CN8, CN15
Rear of the Printer
Tabs
C.B.S. 3x6 (6-8kgf.cm)
C.B.S. 3x6 (6-8kgf.cm)
2
C A U T I O N
 Do not reuse the Shield Plate, FFC once you peel it off.
 Be Careful not to damage the Cable, Head when handling it.
C A U T I O N
 When removing the Holder, Shaft Assy.,
 The PE Sensor comes in contact with the Front Paper Guide
when removing the Holder, Shaft Assy. Be careful not to
damage the sensor.
1
2