Epson Stylus Photo R220 - Page 60

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 60
 External View
Figure 2-17. Holder, Shaft Assy. Removal (2)
 LD Roller Removal
1. Release the two dowels that secure the Paper, Block to the Holder, Shaft
Assy., and remove it.
2. Remove the Shaft, LD Roller and the Clutch from the Holder, Shaft, LD
Roller.
3. Remove the LD Roller.
Paper, Block
Spur Gear, 36.8
Extension Spring 0.143
Shaft, LD Roller
Dowel
Sensor Board, PE
Tab
Torsion Spring, 0.22
Lever Sensor, PE
Holder, Shaft, LD Roller
Clutch
LD Roller
Dowel
Dowel
Dowel
 When reinstalling the LD Roller to the Shaft, LD Roller,
 Do not touch the LD Roller with bare hands.
 Make sure to match the direction (∆Mark) indicated on the
Shaft, LD Roller and the direction (∆ Mark) indicated on the
back side of the LD Roller.
Figure 2-18. Reinstalling the LD Roller
 When reinstalling the Clutch to the Shaft, LD Roller,
 Make sure to put the dowel of the Shaft, LD Roller into the
hole of the Clutch.
 Make sure that the Extension Spring, 0.143 is securely set to
the tabs of the Clutch and the Shaft, LD Roller.
 Do not set the Extension Spring in twisted form.
 Make sure that the Clutch rotates properly.
∆ mark on the Shaft, LD Roller
∆ mark on the LD Roller