Epson Stylus Photo R220 - 2.3 Disassembly

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 45
2.3 Disassembly
The flowchart below lists the step-by-step disassembly procedures. When disassembling each unit, refer to the page number shown in the figure.
Figure 2-1. Disassembly Flowchart
Paper Support Assy./Housing (left/right)/
Stacker Assy. Removal
(2.3.1 P.46)
Housing (frame)/Panel Assy./Panel Board Removal
(2.3.2 P.48)
CR Motor Removal (2.3.4 P.52)
ASF Assy. Removal
(2.3.3 P.50)
Print Head Removal
(2.3.5 P.54)
Porous Pad, Paper Guide, Front
Removal
(2.3.6 P.55)
Holder, Shaft Assy. Removal
(2.3.8 P.59)
Main Board Removal
(2.3.7 P.57)
APG Assy.Removal
(2.3.9 P.62)
Print Head Removal
(2.3.5 P.54)
Main Board Removal
(2.3.4 P.52)
Paper Guide, Upper Removal
(2.3.10 P.63)
Carriage Unit Removal
(2.3.11 P.64)
Printer Mechanism/Housing, Lower Removal
(2.3.12 P.69)
CDR Guide Assy.Removal
(2.3.14 P.73)
Ink System Unit Removal
(2.3.15 P.74)
Paper Guide, Front/Roller, EJ Assy. Removal
(2.3.16 P.76)
Power Supply Board Removal
(2.3.13 P.72)
PF Motor Removal
(2.3.17 P.79)
Start
NOTE: indicates that the part or component in it must be
disassembled to remove the subsequent part or component.
Printer Mechanism/Housing, Lower Removal
(2.3.12 P.69)
C H E C K
P O I N T
Since a prototype was used to illustrate these disassembly and
assembly procedures, the appearance of some parts may differ
from those on Stylus Photo R220/R230.