Epson Stylus Photo R220 - 4.1.3 Lubrication

EPSON Stylus Photo R220/R230 Revision A
MAINTENANCE Overview 98
4.1.3 Lubrication
The lubrication used for each components of Stylus Photo R220/R230 has been
specified on based on the evaluation carried out by Epson. Therefore, when repairing
or carrying out the maintenance work, make sure to apply the specified amount of
lubricant to the specified places.
 When wiping off the grease during the cleaning
 If necessary when performing assembly/disassembly of the printer
 Refer to the following figures for the lubrication points.
C A U T I O N
 Never use oil or grease other than those specified in this manual.
Use of different types of oil or grease may damage the
components or affect the printer functions.
 Never apply a larger amount of oil or grease than specified in this
manual.
Table 4-1. Oil Applied to Stylus Photo R220/R230
Type Name EPSON Code Supplier
Grease
G-26 1080614
EPSON
G-46 1039172
G-63 1218320
C A U T I O N
 When using G-64, it is recommended to use a flux dispenser
(1049533) together.
<Lubrication Point>
1. Contact point between the
Grounding Spring, PF and the
PF Roller
2. Surface of contact point
between the PF Roller and the
Paper Guide, Rear
<Lubrication Type>
1. G-26
2. G-26
<Lubrication Amount>
1. Half periphery of the Roller, PF
2. 4mm x 2 points
<Remarks>
Use a syringe to apply it.
<Lubrication Point>
Inside surface of the Bushing, 5
(Roller EJ Assy.)
<Lubrication Type>
G-26
<Lubrication Amount>
Adequate dose
<Remarks>
Use a cotton-tipped swab to apply
it.
Paper Guide, Rear
PF Roller
Grounding Spring, PF
1
2
Bushing, 5 right
Bushing, 5 left