Epson Stylus Photo R220 - Housing, Frame;Panel;Panel Board Removal

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 48
2.3.2 Housing, Frame/Panel/Panel Board Removal
 External View
Figure 2-4. Housing, Frame Removal
 Parts/Units which should be removed before removing the Housing, Frame/
Panel/Panel Board.
Paper Support Assy./Housing (left/right)
 Disassembly Procedure
 Housing, Frame Removal
1. Remove the screw ( ) that secures the Housing, Frame to the Printer
Mechanism.
2. Remove the screw ( ) that secures Cover, Ink Tube to the Housing, Frame
and then Release the tab ( ) to remove the Cover, Ink Tube.
3. Release the three tabs ( ) that secure the backside of the Housing, Frame
with a flat-blade screwdriver or similar tool.
4. Release the left and right tabs ( ) that secure the front side of the Housing,
Frame.
5. Lift the Housing, Frame to disconnect the connector cable of the Panel Board
FFC from the Panel Board.
6. Remove the Housing, Frame upward.
Rear of the Printer
3
2
4
4
4
Housing, Frame
C.B.P. 2.5x8 (3-5kgf.cm)
Cover, Ink Tube
5
5
Right Front of the Printer
C.B.S. 3x8 (5-7kgf.cm)
1
Panel Board FFC
Control Panel
Left Front of the Printer
1
2
3
4
5