Epson Stylus Photo R220 - Page 49

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 49
 Panel Removal
1. Release the left and right tabs that secure the Panel to the Housing, Frame and
remove the Panel.
Figure 2-5. Panel Removal
 Panel Board Removal
1. Remove the Panel Board lifting upward.
Panel Board
Tabs
 When reinstalling the Housing, Frame
 First connect the Panel Board FFC to CN4 connector on the
Main Board. Then install the Housing, Frame and then
install the Panel Board and the Control Panel.
Figure 2-6. Panel Board Reinstallation
 Make sure that there is no clearance between the Housing,
Frame and the Housing, Lower.
Panel Board
Pull out the Panel Board through this hole.