Epson Stylus Photo R220 - Paper Guide, Upper Removal

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 63
2.3.10 Paper Guide, Upper Removal
 External View
Figure 2-24. Paper Guide, Upper Removal
 Parts/Units which should be removed before removing the Paper Guide,
Upper.
Paper Support Assy./Housing (left/right)/Housing, Frame/ASF Assy./
Holder, Shaft Assy./Main Board Assy.
 Disassembly Procedure
1. Release the three Torsion Springs, 122.2 from each tab of the Frame, Main
and remove it.
2. Release the two tabs that secure the Paper Guide, Upper to the Frame, Main to
upward. Then, release the two dowels while slightly holding up the Paper
Guide, Upper.
3. While holding down the Paper Guide, Lower covered with a transparent sheet,
remove the Paper Guide, Upper rearward of the printer avoiding the two ribs
on the Frame, Main.
PF Roller Assy.
Paper Guide, Upper
Transparency
Torsion Spring, 122.2
Paper Guide, Lower
1
2
Tabs
Dowels
Rib
Rib
Tab
C A U T I O N
 Make sure to cover the surface of the PF Roller Assy. with a
transparent sheet when removing and reinstalling the Paper
Guide, Upper.
 When reinstalling the Paper Guide, Upper on the Frame, Main,
 Make sure that the two dowels of the Paper Guide, Upper is
installed on the Frame, Main, and that the Torsion Springs
122.2 are correctly placed on the Paper Guide, Upper and
the Frame, Main.