Epson Stylus Photo R220 - CDR Guide Assy. Removal

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 73
2.3.14 CDR Guide Assy. Removal
 External View
Figure 2-40. CDR Guide Assy. Removal
 Parts/Units which should be removed before removing CDR Guide Assy.
Paper Support Assy./Housing (left/right)/Housing, Frame/ASF Assy./
Holder, Shaft Assy./Main Board Assy./APG Assy./Print Head/Carriage Unit/
Printer Mechanism
 Disassembly Procedure
1. Remove the three screws that secure the CDR Guide Assy. to the Frame,
Main.
2. Remove the left and right Flat Washer which secure the CDR Link (left/right)
with tweezers.
3. Remove the CDR Link (left/right) from the CDR Guide Assy.
4. Remove the two Pieces of acetate tape which secure the connector cable of the
CDR Sensor to the Frame, Main.
5. Remove the CDR Guide Assy. first from the right edge of it while releasing
the seven ribs that secure the CDR Guide Assy. to the Frame, Main.
1
2
3
C.B.S. 3x6 (6-8kgf.cm)
CDR Link, Left
CDR Guide Assy.
Flat Washer
Flat Washer
Ribs
Acetate Tape
CDR Link, Right
C.B.S. 3x6 (6-8kgf.cm)
Ribs
Ribs
Left Side of the Printer
Right Side of the Printer
 When reinstalling the CDR Guide Assy. to the Frame, Main
 Install the CDR Assy. in the order of left edge, right edge and
middle.
 Check if six ribs are correctly installed.
 Check if the CDR Link (Left/Right) are correctly installed to
the CDR Guide Assy.
 Check if the connector cable of CDR Sensor is not
interfering with the CDR Link, Right.
 Check if Frame, EJ Assy. works with the CDR Guide Assy.
and moves smoothly.
 Tighten the three screws to secure the CDR Guide Assy. in
the order shown in Figure2-40.