EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 58
A D J U S T M E N T
R E Q U I R E D
When impossible to read data from the old board, perform
the following adjustments in order shown below after
replacing the old board with a new one.
1. Replace Waste Ink Pads with a new one.
(To rewrite Protection Counter)
2. Market Setting
3. USB ID Input
4. Protection Counter Input
5. Head ID Input
6. First dot Adjustment
7. PW Sensor Adjustment
8. Head Angular Adjustment
9. Bi-D Adjustment
10. CR Motor Deviation Correction
To Next Page
Loading...
