Epson Stylus Photo R220 - Page 71

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 71
 Make sure that the six Waste Ink Pads are correctly set to
the rib and dowel of the Housing, Lower.
Figure 2-35. Waste Ink Pads
 Tighten the five screws to secure the Printer Mechanism in
the order shown in Figure2-32.
 Tighten the five screws to secure the Paper Guide, CDR in
the order shown in Figure2-32.
 Check if the Waste Ink Tube is secured in the groove of the
Housing, Lower. Then make sure that the line mark on the
tube is facing to the left, and also that it is not twisted.
Figure 2-36. Installation Position for the Ink Tube
 Make sure that the Waste Ink Tube is not squashed or
pressed.
 Check if the Cap Assy. moves smoothly.
Ink Pad, Cap, Lower, Large
Ink Pad, Cap, Lower, Small
Waste Ink Pad,
Upper and Lower
Two Waste Ink Pads, Small
Right Side
Front of the Printer
Rear of the Printer Ink Tube (Image)
Groove of Housing, Lower
Left Side
 Be careful not to drop and damage the Lever, Change and
the Combination Gear, 27.2, 19.2.
Figure 2-37. Lever, Change and Combination Gear, 27.2, 19.2
W A R N I N G
 When installing the Printer Mechanism to the Housing, Lower,
run the Waste Ink tube downward of the tab as shown in
Figure2-38 and securely set in the groove of the Housing, Lower.
Then, make sure that the Waste Ink Pads, Upper, Support is
fitted securely without lifting above the tube upper surface.
Also, the Waste Ink Pad, Upper, Support has to be installed
along the border line as shown in Figure2-38. Incorrect
installation of the Waste Ink Tube may cause the ink leakage.
Figure 2-38. Waste Ink Tube Installation
A D J U S T M E N T
R E Q U I R E D
 When having replaced the Waste Ink Pads with a new ones,
perform the following adjustment.
(Refer to Chapter 3 “ADJUSTMENT”)
1. Protection Counter reset
Combination Gear, 27.2, 19.2
Lever, Change
Waste Ink Pad, Upper, Support
Waste Ink Tube
Border Line
Tab