EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 75
When reinstalling the Ink System Unit
Make sure that the Ink Tube is correctly connected to the
point of the Frame, Cap shown in Figure2-42.
Figure 2-42. Connecting Point of the Ink Tube.
Do not touch the Sealing Rubber Part and the Cleaner Head.
Check if the line mark of the Ink Tube is not twisted.
Check if the Cap Assy. moves smoothly.
Check if all of the gears are correctly set on the shaft of the
Pump Frame, and check if they move smoothly.
Check if the Compression Spring, 2.36 is correctly set to the
Lever, Change.
Make sure that the Ink Tube is not squashed or pressed.
Install the Ink Tube to the two grooves at the bottom surface
of the Cap Frame.
Figure 2-43. Installation Position of the Ink Tube
When reinstalling the Ink System Unit to the Frame, Main
Check if the Pump Assy. is correctly secured.
Be careful not to drop and damage the Lever, Change, the
Combination Gear, 27.2, 19.2, the Spur Gear, 27.2, the
Combination Gear, 20.82, 24.
When reinstalling the Support Plate, Frame, Main
Tighten the two screws to secure the Support Plate, Main in
the order shown in Figure2-41.
To Next Page
Loading...
