Epson Stylus Photo R220 - Page 80

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 80
 Make sure that the PF Motor connector cable is connected to
CN6 on the Main Board connector.
 Tighten the four nuts to secure the PF Motor in the order
shown in Figure2-48.
 Make sure that there is no gap between the Insulator Spacer,
insulator, the PF Motor Insulator and the Frame, Main.
 Make sure to install the Grounding Spring to the position as
shown in Figure2-50.
 Make sure to install the PF Motor to the Frame, Main with
the side shown in Figure2-50 facing the frame.
Figure 2-50. Grounding Spring Installation
Grounding Spring, Motor, PF
Front
Rear