Epson Stylus Pro 3800 - Page 178

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 178
14. Write a line on the ink tube with a pencil at the position shown in Figure 4-116.
15. At the 105 mm lined position, align the upper side edge of the FFC with the ink
tube as shown in Figure 4-117, and wrap acetate tape around the FFC and ink
tube.
16. At the 250 mm lined position, wrap acetate tape around the ink tube.
17. Attach the Holder, FFC to the taped portion of the ink tube and secure the FFC and
GUIDE, TUBE, CR together with the ink tube.
Figure 4-116. Writing a line on the Ink Tube
Figure 4-117. Securing the FFC
250 mm
105 mm
Write a line
HOLDER,FFC,TUBE
Edge face of
HOLDLER,FFC,TUBE
Write a line
Holder, FFC
FFC
GUIDE, TUBE, CR
Ink tube
Acetate tape
FFC
Upper side edge of FFC
GUIDE, TUBE, CRInk tube
Holder, FFC
Step 17 Step 15
Lined position
Lined position