Epson Stylus Pro 3800 - Page 180

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 180
C A U T I O N
Before carrying out the following procedure, perform check 1 to 3
below. When one of them is not satisfied, go back to
Step12 to
reassemble the CABLE ASSY., ASP again.
 Check 1
The gap between the Frame R and GUIDE, TUBE, CR is 2 mm
or more.
 Check 2
Insert a sheet of copy paper (30 mm x 150 mm) between the ink
tube and FFC, and move it from side to side between the clamp
and carriage. The paper moves smoothly without getting stuck.
Frame R
2 mm or more
GUIDE, TUBE, CR
Copy paper
Clamp
30 mm
C A U T I O N
 Check 3
The gap between the guide plate and ink tube is 5 mm or less.
5 mm or less
Ink tube