Epson Stylus Pro 3800 - Page 181

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 181
21. Align the fold line of the FFCs with the right edge of the main frame, and secure
the FFCs to the main frame with double-sided tape.
22. Fold the FFCs back on themselves so that the folded portion do not extend off the
positions marked on the front side of the main frame, and adjust the FFCs to take
any slack.
23. Secure the FFCs with acetate tape on the position shown in Figure 4-120.
24. Fold back the FFCs on the position shown in Figure 4-121, and secure the FFCs
with acetate tape.
25. Route the FFCs on the COVER, HOUSING, LOWER, and secure them to the
COVER, HOUSING, LOWER with double-sided tape.
Figure 4-120. Securing the FFC
Figure 4-121. Routing the FFCs on the Right Side of the Main Frame
C A U T I O N
When folding back the FFCs with the following steps, make sure
that the gap between FFCs are 5 mm or less. See Figure 4-121.
Acetate tape
Mark
Right edge of main frame Double-sided tape
Acetate tape
FFC
Main frame
Mark
Mark
Acetate tape
Double-sided tape
Within 5 mm
COVER, HOUSING, LOWER
Within 5 mm