Pro 7900 and 9900 Field Repair Guide 10/6/10
Printer Component, Software Item, LCD Display, Printer Button Page 14.
Fan: Fan Adjust *0% (-10% to +10%) (Adjusts Suction Fans)
Temporary PG: [Enter]Un Cap (Releases the Carriage Mechanism)
PF Head Slant: [Enter]Print (Prints the PF Slant adjustment pattern)
CR Head Slant: [Enter]Print (Prints the CR Slant adjustment pattern)
PG Adj: [Enter]Un Cap (Releases the Carriage Mechanism)
CR Scale: [Enter]Start (Excercises the Carriage Motor and Encoder)
CR Active Dumper: All, 240CPS, 300CPS, Hybrid
AIDCheck: [Enter] Start (Test the AID circuitry)
IM Sensor: [Enter]Print (do not perform)
Gap Adj: (Auto Bi-d and Uni-d)
Auto Uni-D, [Enter]Print
Auto Bi-D, [Enter]Print
Feed Adj: (990.6mm adjustment)
Printing: [Enter]Print
Input: Feed Adj Value: (n:nn)mm
Cutter: (Test the Cutter Mechanism)
Printing: [Enter]Print
Input: Cut Position Home: (n:n)mm
TBS Pos: (Margin adjustments)
Printing: [Enter]Print
Input: Top Margin: (n:n)mm
Pad Position: [Enter]Print (Checks the borderless pad position carriage timing)
Measurement:
Mecha,[Enter]Start
Ink System, [Enter]Start
Print Adj. Variable: [Enter] Print (Prints the numeric adjustment variables currently set)
Board Paper Check: Please Set Board, [Enter]Start
LCD RGB Check: Red, Green, Blue
Counter Check: [Enter] Start
Counter Clear: [Enter] Start
To Next Page
Loading...
