D
Align the media and the roll holders.
Raise or lower the lifter until the media roll core is
level with the roll holders.
E
Fully insert the left roll holder. Next, tighten the
roll holder screw to fix the roll holder in place.
F
Fully insert the right roll holder. Next, tighten the
roll holder screw to fix the roll holder in place.
G
Remove the lifter.
H
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll holder.
If part A is not hidden even after turning the
handle until it can no longer be turned, return
to step 6 and fully press the right unit into the
roll core.
I
Raise the media loading lever.
SC-S30600 Series User's Guide
Basic Operations
29
To Next Page
Loading...
