Epson SureColor T-Series - Page 53

Epson SureColor T-Series User’s Guide
Basic Operations
53
Buttons that are used in the following settings
1
Set the auto take-up reel unit Auto switch to Off.
Plug the power cord into an outlet and confirm
that the power lamp lights.
2
Turn on the printer by pressing the P button.
3
Check that the roll paper is correctly loaded in
the printer.
4
Press the ) button on the control panel.
Keep the d button pressed until the end of the
roll reaches the roll core.
5
Tape the end to the roll core.
Place tape (available from third-party suppliers)
at the center and then at the left and right ends.
6
Keep the d button in the control panel pressed
until you have fed enough paper for about three
wraps around the roll core.
7
Keep the Manual switch pressed to Forward to
wrap the paper three times around the core.