Appendix
80
H
Select the printer from the Registered Printer List, and then click Pre-operation Check.
I
While the Pre-operation Check is running, the Printer PC (if connected) and the printer’s firmware are
upgraded or downgraded. The Pre-operation Check for upgrading or downgrading may take approximately
10 minutes longer than a normal Pre-operation Check because the system application version is being
changed and the Printer PC will be restarted. After the Pre-operation Check is finished, the printer restarts
and is ready to print.
Tip:
When multiple printers are registered to the Client PC, the Client PC's system application is upgraded or
downgraded first. When you start the Pre-operation Check the first time after upgrading or downgrading the
Client PC, the Printer PC's system application and the firmware in the printer are upgraded or downgraded.
To Next Page
Loading...
