Rev. A Product Overview 1-7
TM-T88II/T88III Technical Reference Guide
3. Pull out the roll paper toward you.
4. Close the printer cover.
Figure 1-8 Closing the printer cover
5. Tear off the leading edge of the roll paper using the manual cutter.
Figure 1-9 Tear off paper
1.3.2.2 Replacing Paper
Follow the procedure below to replace roll paper.
1. Open the printer cover, and remove the core of the previously used roll paper.
2. Insert the new roll paper following the procedure in “Installing Roll Paper” (page 1-6).
1.3.3 Power Switch Cover
Install the power switch cover that comes with the TM-T88II/TM-T88III onto the printer to
prevent inadvertent changing of the power switch, to prevent tampering, and to improve the
appearance of the printer.
To reset the TM printer when the power switch cover is installed, insert a long, thin object (such
as the end of a paper clip) into the hole in the power switch cover and press the power switch.
ERROR
POWER
PAPER
OUT
FEED