Rev. A TM-T88II/TM-88III Comparison Table D-1
TM-T88II/T88III Technical Reference Guide
Appendix D
TM-T88II/TM-88III Comparison Table
* For details on the conditions for canceling the receive buffer BUSY state, refer to ’ DIP Switch Functions, ’ (page 2-3).
TM-T88III TM-T88II
1. High-speed print mode Approx. 150 mm/s {5.91"/s}
(4.72") maximum
Approx. 120 mm/s {4.72"/s}
(4.72") maximum
2. High-speed power
consumption mode
Average approx. 1.8 A Average approx. 1.7 A
3. Serial interface selectable
baud rates
4800, 9600, 19200, 38400, (2400
discontinued; 38400 added). 38400
selected by setting DIP SW1-7 and 1-8
to ON.
2400, 4800, 9600, 19200
4. Conditions for canceling
receive buffer BUSY state *
Set on DIP SW2-5 * Cannot be changed
5. Supported character sets
(extended graphics) *
11 pages
including WPC 1252,
PC866 [Cyrillic #2], PC852 [Latin2])
8 pages
6. Driver (EPSON OPOS ADK,
Advanced Printer Driver )
Also can be operated by the TM-T88II
driver. Functions, however, are
restricted as follows:
• Some baud rates cannot be used in
serial communications (38400 bps,
2400 bps).
Note: The driver cannot set a
38400 bps baud rate. Selecting
a 2400 bps baud rate with the
driver causes garbled
characters (the printer does not
support a 2400 bps baud rate).
—
To Next Page
Loading...
