153
Chapter 3 Handling
3
PAP E R O U T E R ROR
Paper out error
Paper has run out during
printing
If any paper remains in the paper path,
remove it. Then set new paper in place.
PAPER PATH ERROR
Paper path error
The paper supply method for
the paper set is different from
the method specified in the
“Media supply method
settings”.
Set paper in place that is appropriate for
the “Media supply method settings”, or
change the “Media supply method
settings” to suit the paper.
PAPER REMOVAL
ERROR
Paper removal error
Paper is not set correctly in
place, or paper has not been
removed after ejection
operation.
If no paper remains on the platen:
Set paper in place again.
See Appendix C for how to set the paper in
place.
If paper remains on the platen:
1. Open the paper set cover.
2. Open the front cover.
3. Remove all the paper that is in the paper
path.
4. Close the front cover.
5. Run auto loading of the paper.
When there is not much roll
paper left, printing ended near
the end of the roll paper.
Replace the roll paper.
ROLL COVER OPEN
Roll paper cover open
The roll paper cover is open. Close the roll paper cover.
PAPER COVER OPEN
Paper set cover open
The paper set cover is open Close the paper set cover.
FRONT COVER OPEN
Front cover open
The front cover is open Close the front cover.
INK COVER OPEN
Ink cartridge cover
open
The ink cartridge cover is open. Close the ink cartridge cover.
NO INK CARTRIDGE
No ink cartridge
An ink cartridge is not loaded 1. Open the ink cartridge cover.
2. Load an ink cartridge with sufficient ink
left.
3. Close the ink cartridge cover.
INK READ ERROR
Ink cartridge read error
The ink cartridge information
could not be read.
1. Open the ink cartridge cover.
2. Remove the ink cartridge.
3. Load the ink cartridge again.
4. Close the ink cartridge cover.
5. If the error occurs again, replace the ink
cartridge with a new one.
LCD display
Error
Description Recovery method
To Next Page
Loading...
Need help?
General
