Epson TM-C7500G series

189
Appendix
When "Extend Printable Area" is enabled
Ver tical margins: 1.5 mm {0.06"} (Typical value)
Lateral margins: 0 mm (Typical value)
 If you enabled "Extend Printable Area", printing is done with settings for no margins, but the
printing might protrude beyond the paper/label, depending on the actual print position and
the set position for the paper/ label. To make sure printing doesn’t protrude out, ensure mar-
gins of 1.5 mm {0.06"} or more in the print data.
 The distance from the paper cut position to the black mark leading edge must be at least 1.5
mm {0.06"}. If it is less than 1.5 mm {0.06"}, the printer may be unable to print pages
because it fails to sense their black marks or skips them, etc.
Black mark position
Paper
Label area
Print area
Auto-cut position
Auto-cut position
Print area width
Paper width
Paper feeding
direction
1.5 mm { }
0.06”
1.5 mm { }
0.06”
25.4 mm { } or more
1.0”
28 mm { } or more
1.12”
Outer edge
(Removed)
2.0 mm { }
0.08”
Outer edge
(Removed)
2.0 mm { }
0.08”