Epson tm-m30

114
Bluetooth Interface
Specification
• Bluetooth 3.0 (EDR supported)
• Bluetooth Power Class 2
• Built-in antenna
• Pass key setting is possible
• Device name setting is possible
• Pairing information of up to 8 devices can be registered
Initial Settings
Auto Reconnect Feature
The auto reconnect feature allows the printer to automatically restore a connection in the following situations if
the Bluetooth connection to the iOS device is lost.
• When the printer is turned on
• When the signal is dropped and then restored
The following shows the printer operations and connection methods when the auto reconnect feature is enabled
or disabled.
Countries and regions where Bluetooth can be used are limited. Since notes are provided for each
country, check the sheet supplied with the product.
Setting Contents Setting Items Initial Settings
Bluetooth communication
settings
Bluetooth passkey "0000"
Bluetooth device name "TM-m30_xxxxxx"
(Where xxxxxx is the last six digits in the serial
number)
Bundle Seed ID "TXAEAV5RN4"
Enable/Disable auto reconnect to
iOS device
"1" (Enable)
Bluetooth Security Low
Bluetooth communication interval
during power saving mode
Level 1 (Standard)