Epson tm-m30

49
Chapter 3 Advanced Usage
3
Release condition of receive buffer BUSY
• Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
• Releases when the remaining receive buffer capacity becomes 138 bytes
Select paper out detector enabled for paper out signal output
• Roll paper out detector (initial settings)
• Disabled
Error signal settings
• Enabled (initial setting)
• Disabled
Pre-feed before next print
• Disabled (initial setting)
• Enabled
Paper width
• 80mm (initial setting)
• 58mm
This function is enabled only when Receive buffer capacity is set to 4KB.
This is available for firmware version 1.10 ESC/POS or later.
• When using this function, the top margin is approximately 10.5 mm.
• This setting becomes invalid if you change the "Amount of top margin by backfeed" setting from
the initial setting (9.5 mm (no backfeed)).