63
Chapter 3 Advanced Usage
3
• Interface switch waiting time
• Main connection interface
• Pre-feed before next print
Follow the steps below.
1
After running a self test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
Briefly press the Feed button three times (less than one second), hold it down for at
least one second to enter the Software settings mode (Customized value setting).
The Software setting mode guidance is printed, and the Paper LED flashes.
For details on the memory switches and customized values, see "Software Settings" on page 47.
Customize Value Settings
Modes
0: Exit
1: Print Current Settings
2: Print Density
3: Automatic Paper Reduction
4:
Auto Paper Feed&Cut at cover close
5: Paper Width
8: Embedded Font Replacement
9: USB Interface Settings
10: Printing Speed
11: NV Capacity
12: Command Execution (Oine)
13: Buzzer Control
14: Interface Settings
15: Other Settings
Select Modes by executing following
procedure.
step 1. Press the Feed button less
than 1 second as many times
as the selected mode number.
step 2. Press Feed button for 1
second or more.