EasyManuals Logo

Epson VT Series User Manual

Epson VT Series
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
Setup & Operation 17. Fieldbus I/O
VT Rev.1 111
17. Fieldbus I/O
Fieldbus I/O of the VT series supports the following model.
DeviceNet™
PROFIBUS-DP
EtherNet/IP™
CC-Link
PROFINET
EtherCAT®
For details, refer to the following manual.
Robot Controller RC700 / RC90 Option Fieldbus I/O
WARNING
Do not connect or disconnect the motor connectors while the power to the robot
system is turned ON. Connecting or disconnecting the motor connectors
with
the power ON is extremely hazardous and may result
in serious bodily injury as
the Manipulator may mo
ve abnormally, and also may result in electric shock
and/or malfunction of the robot system.
To shut off power
to the robot system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle.
DO NOT
connect it directly to a factory power source.
Be sure to perform installing procedure with turning OFF the robot system and
related equipment and disconnect the power plug. Performing any replacement
procedure with the power ON is extremely hazardous
and may result in electric
shock and/or malfunction of the robot system.
CAUTION
Check the tabs of the fieldbus I/O module are securely hooked on the board
when installing fieldbus I/O module. If tabs do not be hooked securely,
connecter or fieldbus I/O module may get damages.

Table of Contents

Other manuals for Epson VT Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson VT Series and is the answer not in the manual?

Epson VT Series Specifications

General IconGeneral
BrandEpson
ModelVT Series
CategoryRobotics
LanguageEnglish

Related product manuals