Setup & Operation 3. Environments and Installation
VT Rev.1 35
3.8 Relocation and Storage
3.8.1 Precautions for Relocation and Storage
Observe the following when relocating, storing, and transporting the Manipulators.
THE INSTALLATION SHALL BE PREFORMED BY QUALIFIED INSTALLATION
PERSONNEL AND SHOULD CONFORM TO ALL NATIONAL AND LOCAL
CODES.
WARNING
â–
Only authorized personnel
should perform sling work and operate a crane and a
these operations are performed by unauthorized personnel, it is
hazardous and may result in serious bodily injury and/or severe
equipment damage to the robot system.
Stabilize the Manipulator with your hands when hoisting it. Unstable hoisting is
extremely hazardous and may result in serious bodily injury and/or severe
equipment damage to the robot system as the fall of the Manipulator.
When removing the anchor bolts, support the Manipulator to prevent falling
.
Removing the anchor bolts without
supporting the Manipulator may get hands,
fingers, or feet caught as the Manipulator may fall
transport the Manipulator, secure it to the delivery equipment or have at least 2
people to hold it by hand. Also, do not hold the bottom of the base (the
screened parts in the figure). Holding these parts by hand is extremely
hazardous and may cause your hands and fingers caught.
VT6-A901* : Approx. 40 kg: 89 lb.
DO NOT hold the bottom of the base
by hand.
Make sure not to hold the
power unit when transporting the manipulator.
void excessive vibration or shock during Manipulator transporting.
Excessive vibration or shock may cause equipment damage and/or malfunction
of the Manipulator.
the Manipulator with your hands when hoisting it. Unstable hoisting is
extremely hazardous and may result in fall of the Manipulator.
When transporting the Manipulator for a long distance, secure it to the delivery
equipment so that the Manipulator
. If necessary, pack the
Manipulator in the same way as it was delivered.