Status Menu Error Codes
If a job does not complete successfully, you can check the error code. Press the Status button, select
Job History, and locate the incomplete job. Select the job to display the error code and additional
information.
Code Condition/solution
001 The product was turned off by a power failure.
109 The received fax was already deleted.
110 The job was printed 1-sided because the loaded paper does not support 2-sided printing.
201 The product's memory is full.
You can send pages individually or print received faxes and then delete them to free up
memory space.
202 The line was disconnected by the recipient's fax machine. Wait a moment, then try again.
203 The product cannot detect a dial tone.
Make sure the phone cable is connected correctly and the phone line works. If you
connected the product to a PBX (Private Branch Exchange) phone line or Terminal
Adapter, turn off the Dial Tone Detection setting.
204 The recipient's fax machine is busy. Wait a moment, then try again.
205 The recipient's fax machine does not answer. Wait a moment, then try again.
206 The phone cable is incorrectly connected to the product's LINE and EXT ports. Connect
the phone cable correctly.
207 The phone cable is not connected. Connect the phone cable.
208 The fax could not be sent to some of the specified recipients.
Print a fax log to check which recipients failed to receive the fax. You may be able to
resend a fax from Job Monitor in the Status Menu.
301 There is not enough storage space available on the external memory device. Clear space
on the device or use a different device.
401
302 The external memory device is write-protected; disable write protection.
402
260
To Next Page
Loading...
Need help?
General
