Epygi QX series Administrator's Guide

QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x) 141
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
Parameter System Default Value
Off-hook caller ID – disabled for all lines
Hot Desking Capability – disabled for all lines
FXO Settings
(for QXFXO4 gateways)
4 FXO lines exists on QXFXO4
All lines enabled, incoming and outgoing calls allowed and routed to 00 Attendant on
all lines
E1/T1 Settings
(for QXE1T1 gateways)
Trunk 1 exists on QXE1T1
Trunk mode - E1
Interface Type – User
Signaling – CCS
Line Code – HDB3
Frame Mode – NO_CRC
Line Build Out – 120-ohm
Coding - a-law
LoopBack Mode - No_loopback
Clock Mode – Slave
TEI mode – non automat, TEI address -0
SAPI Value – undefined
Alternative Disconnect Mode – enabled
Excessive Ack. Delay T200 – 4000
Idle Timer T203 – 12000
T302 timer – 4000
T309 timer – 0
T309 timer – 60000
D Channel Timeslot for Transmit/Receive – 16
B channels - 1-31 timeslots are enabled
Echo Cancellation - enabled for all B channels
Channels Selection – preferred
Channels Selection Ordering – ascending
Bearer Establishment Procedure – on progress indication with in-band information,
Called Party Type of Number and Calling Party Type of Number – Unknown,
Called Party Numbering Plan and Calling Party Numbering Plan – ISDN/telephony
numbering plan
Route Incoming Call to – 00
Switch Type - primary_dss1
Generate Progress Tone to PSTN/PBX – None
Incoming Called Digits Size – 1
Generate Progress Tone to IP – disabled
Send ALERT Message on Call Routing – disabled
Enable CLIR Service – disabled
Enable Connect Acknowledge Option – enabled
Override CLID with P-Asserted-Identity –disabled
ISDN Settings
(for QXISDN4 gateways)
ISDN Trunks – 4 trunks exists on QXISDN4.
Settings for all available Trunks:
State – started
Interface Type – User
Connection Type - PTMP( Point To Multi Point)
Service Type – No MSN
Route Incoming Call to - 00
Use Default outgoing Caller ID – enabled
Default outgoing Caller ID – undefined
Advanced Settings – disabled
PSTN Lines Sharing
(for QXFXO4, QXISDN4 and QXE1T1
gateways)
Provide PSTN lines for master device – disabled
PSTN Gateway Operation Mode
(for QXFXO4, QXISDN4 and QXE1T1
gateways)
Slave mode
VoIP Carrier
(for QXFXO4, QXISDN4 and QXE1T1
gateways)
VoIP Carrier – Manual
Description – undefined
Call Routing Table
2 entries defined for a call - calls to extensions and calls to SIP
Call Routing
Route all incoming SIP calls to Call Routing – disabled
Local AAA Table
Local AAA Table – Authentication by Caller ID – enabled
Global Speed Dial Directory
Undefined
SIP Tunnel Settings
Enable Tunnels to Slave Devices – disabled

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English