4 Start-up and Preparation
ers2 – 1-Channel ECG Telemetry System 29
201000401000 / Rev 04
4.2 1-Channel Transmitter
During commissioning, an ergoline service partner needs to configure the 1-channel transmitter in
the application software.
• Clean and disinfect the 1-channel transmitter according to the instructions in this manual.
• Insert the AAA battery into the 1-channel transmitter according to the instructions in this
manual.
• Switch on the 1-channel transmitter according to the instructions in this manual for the nor-
mal operation mode.
• After switch-on, check the LED status on the 1-channel transmitter to verify the operating status.
• Switch off the 1-channel transmitter according to the instructions in this manual for the normal
operation mode.
After starting the PC system and the application software, the activated 1-channel transmitter
is ready for operation. The connection to a 1-channel transmitter that has been switched on and
configured appropriately occurs automatically via the application software.
Shutting down the PC system and switching off the 1-channel transmitter deactivates the trans-
mitter.
To Next Page
Loading...
Need help?
General