4 Start-up and Preparation
ers2 – 1-Channel ECG Telemetry System 31
201000401000 / Rev 04
The 1-channel transmitter is powered from a commercially available, rechargeable AAA battery.
• Open the battery compartment of the 1-channel transmitter by turning the cover counter-
clockwise.
• To remove a battery, hold the 1-channel transmitter in one hand and tilt it a bit, allowing the
battery to slide out of the compartment.
• For insertion of a charged battery, hold the 1-channel transmitter upright in one hand or place
it vertically on a table. Insert the charged battery in the battery compartment of the 1-channel
transmitter with the minus pole first.
• Then place the cover on the thread and turn the cover approx. one and a half revolution clock-
wise to close.
• After switch-on, check the LED status on the 1-channel transmitter to verify the operating status.
4.2.2 Battery Management of the 1-Channel Transmitter
The 1-channel transmitter is powered from a commercially available, rechargeable AAA battery.
A fully charged battery provides power for at least 6 hours.
To ensure optimal performance of the 1-channel transmitter, start the daily therapy sessions with
a fully charged battery. If you follow this advice, you will not have to replace the battery between
training units. We recommend replacing a battery with a charged battery after 5 to 6 operating hours.
To Next Page
Loading...