Operation and Maintenance Terminal
The functions above are normally used for:
• General purposes (display RBS configuration)
• Maintenance (display RBS software revisions)
• Installation (display TEI/RU list)
28.3.3 OMT Connection
The following user functions, related to the OMT, are available in the
OMT:
• Connect, establish a connection between the OMT and the RBS.
A functionality and compatibility check is performed on RBS and
OMT software versions. In case of different versions the OMT
operator is informed about this fact and that all functionality is
not supported.
• Disconnect, release the connection between the OMT and the
RBS.
The functions above are used for general purposes.
28.3.4 Installation Database
The following user functions, related to the IDB, are available in the
OMT:
• Read, copy the IDB from the RBS to the OMT.
• Install, copy the IDB from the OMT to the RBS.
• Save, copy the IDB from the OMT to any file media for example
a floppy disk or a hard disk.
• Open, copy the IDB from any file media to the OMT.
• Print, print the IDB in formatted ASCII.
• Configure, generate a new configuration.
• Reconfigure, copy data from the old IDB to the new IDB.
• Modify, increase or decrease the number of activated RUs in the
IDB.
The functions above are used for general purposes.
28.3.5 External Alarms
The following user functions, related to the external alarms, are
available in the OMT:
• Display external alarm setup, display the external alarm setup
parameters (see chapter External Alarms) associated with each of
the external alarm inputs.
• Define external alarm setup.
• Monitor external alarms status, the status (on/off) of the external
alarms is continuously monitored and displayed.
The functions above are normally used in connection with:
EN/LZT 123 2697 R5A
1998-08-13
171 (306)
© Ericsson Radio Systems AB
— All Rights Reserved —
To Next Page
Loading...
