Operation and Maintenance Terminal
• Display FDL use.
The functions above are normally used at:
• Installation (set transmission interface type, set/display available
synchronization source, display/define spare bits, display/switch
on/switch off CRC-4).
• Maintenance (monitor maintenance data).
28.3.8 Antenna System
The following user functions, related to the antenna system, are
available in the OMT:
• Monitor maintenance data, display any of the following data and
update changes continuously:
− Diversity
The functions above are normally used for maintenance.
28.3.9 Transceiver
The following user functions, related to the transceivers, are available in
the OMT:
• Switch on QIU, switch on subjective speech quality improvements
uplink for one or more traffic channels within one transceiver
1)
.
• Switch off QIU
1)
.
1)
Facilitates BER measurements according to /GSM:11.20/ and /
GSM:05.05/.
• Monitor maintenance data, display any of the following data and
update changes continuously:
− Transmission and reception
− Timing advance
• Switch on Measurement Reports, switch on Measurement Reports
for one or several timeslots.
• Switch off Measurement Reports, switch off Measurement
Reports for one or several timeslots.
The functions above are normally used at:
• Maintenance (switch on/off QIU, Monitor maintenance data)
• Installation (switch on/off Measurement Reports)
28.3.10 Managed Object
The following user functions, related to the MOs, are available in the
OMT:
• Display state, display the current state of the selected MO.
• Display relation, display which Main RU the selected MO is
executing on.
EN/LZT 123 2697 R5A
1998-08-13
173 (306)
© Ericsson Radio Systems AB
— All Rights Reserved —
To Next Page
Loading...
