26
iPlex Installation and Hardware Specification Guide
Hardware
This chapter outlines TANDBERG Television’s iPlex hardware specifications and
component installation instructions.
iPlex Specifications
Mechanical Dimensions (HxWxD): 23.50 x 17.40 x 1.75 inches (59.69 x 44.20 x 4.45 cm)
Rack Mount: 1 Rack Units: Standard 19 inch EIA rack
Weight: 24.5 lbs. (11.14 kg) fully configured
Shipping Weight: 39 lbs. (17.69 kg)
Operating
Environment
Airflow: 86 CFM normal operation, 126 CFM maximum
Operating Temperature Range: 0° C to +40° C (+32° F to +104° F)
Short-term Operating Temperature Range: -5° C to +55° C (+23° F to 131° F)
Non-operating Temperature Range: -40° C to +70° C (-40° F to +158° F)
Operating Humidity: 7% to 95% Non-condensing
Non-Operating Humidity: 5% to 95% Non-condensing
Operating Altitude: to 13,123 ft (4000 meters)
Power Rating and
Specifications
Input Power Requirements:
•
AC: 100-240 V 47/63 Hz @ 3/6 Amps max.
•
DC: -48 V @ 10 Amps max.
Power Outlet
Installation
Requirements
The AC and DC power outlets must be installed near the equipment and must be
easily accessible.
Floor Planning
Requirements
The iPlex requires the following:
•
Adequate aisle clearance for service and maintenance access, with a minimum
clearance of two feet in front of the rack or cabinet rails
•
Adequate rack space for cable management, routing, and lacing
•
Adequate proximity to the power source and grounding point
•
Chassis and surrounding equipment must be positioned so that vents are not blocked
and the fans can pull cool air in through the lower vents and exhaust air out the upper
vents
•
Adequate vertical spacing between equipment in the rack to allow component
replacement and to prevent conduction of heat
To Next Page
Loading...
