60
iPlex Installation and Hardware Specification Guide
Installing a Submodule into the Carrier
Card
To install a submodule, first attach a grounding strap to your wrist. Then carefully
place the carrier card on a static-free workbench so that the components are face
up
Use the following procedure to install a submodule into the carrier card.
To install a submodule into the MCM blade:
1
Carefully remove the submodule from its anti-static bag.
NOTE
You must properly ground yourself when installing or removing
iPlex
modules. Wear an anti-static wrist-strap and do not touch any com-
ponents inside the
iPlex
chassis, as static electricity may cause irre-
versible damage.
To Next Page
Loading...
