EasyManua.ls Logo

Ericsson TANDBERG Television iPlex N20001 - Iplex Chassis Basic Components; Front Bezel; Front Bezel Leds; Using the LCD Interface

Ericsson TANDBERG Television iPlex N20001
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iPlex Installation and Hardware Specification Guide
35
iPlex Chassis Basic Components
The basic components of the TANDBERG Television iPlex chassis are shown in
the illustrations as follows.
Front Bezel The iPlex front bezel consists of an LCD display and keypad for entering machine
ID and IP addresses, and a series of LEDs that display system status.
Front Bezel LEDs The LEDs on the front panel indicate the following:
Power Green when all power rails are up and within specifications. The LED is
off if the iPlex encounters a power rail failure
Online Green when iPlex completes booting, configured, and in an active state.
Otherwise, the LED is off
SCM Active Orange when booting, green when the iPlex completes booting
MCM Active Flashing orange when idle waiting for the SCM to complete boot-
ing, solid orange when booting, green when the iPlex completes booting
ETH1 Link/Activity Green when the link is established, flickering green when
there is network activity, off when no link is established
ETH2 Link/Activity Green when the link is established, flickering green when
there is network activity, off when no link is established
GE1 Link/Activity Green when the link is established, flickering green when
there is network activity, off when no link is established
GE2 Link/Activity Green when the link is established, flickering green when
there is network activity, off when no link is established
Major Alarm Red when in major alarm state. Off when not in alarm state
Minor Alarm Red when in major alarm state. Off when not in alarm state
Using the LCD
Interface
The iPlex uses and LCD display with a six-button keypad that enables you to per-
form the following basic system configuration at the iPlex. There are two types of
screens: menu screens and text entry screens.
Set date and time
Set Flash and TFTP boot
Network configuration
Syslog configuration
Set host name and password
ST
A
T
U
S
AC
TIVE LI
NK
AC
TIVE
A
L
AR
M
POWE
R
O
N
LI
N
E
S
C
M
M
C
M
ET
H1
ET
H2
GE
1
GE
2
M
AJ
O
R
M
I
N
O
R

Table of Contents

Related product manuals