50
iPlex Installation and Hardware Specification Guide
Specifications
Mechanical
Height: 0.509 inches
Width: 2.913 inches
Depth: 5.866 inches
Multi-mode Connector: SC duplex, multi-mode fiber, 62.5/125 micron
Single-mode Connector: SC duplex, single-mode fiber, 8.5/125 micron
Indicators
LINK—Link Up Green LED
STATUS—Active Green LED, Initializing Yellow LED
ATM DS3/E3 The ATM DS3 and ATM E3 adapters offer an additional interface, but the func-
tionality is essentially the same as the other ATM cards.
ATM DS3
ATM (Asynchronous Transfer
Mode) A network technology for
both local and wide area
networks (LANs and WANs) that
supports real-time voice and
video as well as data. The
topology uses switches that
establish a logical circuit from end
to end, which guarantees quality
of service (QoS).
State Link Status
Power Off or Not Initialized Off Off
Receiving signal from switch or remote system On/Green Off
Power On or Initializing On/Green On/Yel-
low
Indicates driver is loaded and interface is config-
ured (flashes yellow and then flashes green for 0.5
seconds each)
On/Green Flashes
To Next Page
Loading...
