74
iPlex Installation and Hardware Specification Guide
Setting Up the iPlex Control Station
This chapter will guide you through the steps necessary to set up the Tandberg
iPlex control station.
Dependencies
Before you start to set up the iPlex, make sure that you have the following items:
•
iPlex chassis containing a minimum of:
■
one carrier card
■
one submodule
•
Separate management PC with Web browser (if not using the front panel of the iPlex to
reconfigure the unit).
•
Cables required to connect to your network configuration.
Management PC The Management PC (if used) must be capable of running Internet Explorer 5.5+
(IE 6.0) or Netscape 6.0.
Reconfiguration
of the iPlex Using
the Front Panel
Controls
To avoid needing a management PC connected to the serial port, the iPlex allows
you to reconfigure the IP address and related information using the front panel
controls:
•
IP address
•
IP mask
•
IP gateway
•
root password
•
date/time
•
boot source
To Next Page
Loading...
