iPlex Installation and Hardware Specification Guide
57
GE Copper Cable
SFP Module
Small Form Factor Pluggable (SFP) 1000BASE-T copper transceivers are used by
the iPlex to provide electrical connections to the network. The 1000BASE-T SFP
transceiver uses an RJ-45 connector with CAT-5, 5e, or 6 UTP/FTP cable to pro-
vide 1000BASE-T full-duplex connectivity between modules and the network up
to a distance of 328 feet (100 m).
NOTE GE Copper SFP Modules, by design, cam only work at 1 Gb/s and require
auto-negotiation. They will not operate at 100 Mb/s or 10 Mb/s.
Cables
This section provides a list of recommended cables for use with the iPlex.
ASI Input Cables
•
Coaxial cable, RG 6/U (75 ohm) with BNC male connector
ASI Output Cables
•
Coaxial cable, RG 6/U (75 ohm) with BNC male connector
ATM Cables
•
Single-mode fiber cable, 8.5/125
μ
m duplex with SC connector
•
Multi-mode fiber cable, 62.5/125
μ
m duplex with SC connector
Real-Time MPEG
Encoder Plus and
Advanced Encoder
Cables
Custom Cables Supplied by TANDBERG Television
•
Balanced audio cable, 4 XLR jacks to 1 Micro-D connector (6 ft)
•
Unbalanced audio cable, 4 RCA jacks to 1 Micro-D connector (6 ft)
•
AES audio cable, 2 XLR jacks to 1 Micro-D connector (6 ft)
Video Cables not Supplied by TANDBERG Television
•
S-video cable, 4-pin plug to 2 BNC male connectors (75 ohm)
Suggested vendor: Comprehensive Video Group (S4P-YC-6)
•
Composite video cable, RG 6/U (75 ohm) with BNC male connector
•
SDI cable, RG 6/U (75 ohm) with BNC male connector
Gigabit Ethernet
Cables
•
Single-mode fiber cable, 9/125
μ
m duplex with LC connector
•
Multi-mode fiber cable, 62.5/125
μ
m duplex with LC connector
To Next Page
Loading...
