30
iPlex Installation and Hardware Specification Guide
•
To attach a mid-mounted chassis, attach the rack-mount screws as shown in the figure below.
WARNING
To prevent personal injury or damage to the chassis, only lift the
iPlex by grasping the chassis beneath its lower edge. A fully config-
ured chassis weighs 24.5 pounds. Two people are required to lift the
chassis and install it into a rack. It is recommended that one person
holds and secures the chassis into the rack while a second person
installs the rack-mounting screws. To prevent injury, keep your back
straight and lift with your legs, not your back.
WARNING
To prevent personal injury when mounting or servicing the unit in a
rack, you must take special precautions to ensure that the system
remains stable. The following guidelines are provided to ensure your
safety:
•
When mounting this unit in a partially filled rack, load the rack from the
bottom to the top with the heaviest component bottom-most.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting the unit in the rack.
ST
A
T
U
S
AC
TIVE
LI
NK
AC
TIVE
A
L
AR
M
POWE
R
O
N
LI
N
E
S
C
M
M
C
M
ET
H1
ET
H2
GE
1
GE
2
M
AJ
O
R
M
I
N
O
R
To Next Page
Loading...
