Ericsson TANDBERG Television iPlex N20001 - Page 81

iPlex Installation and Hardware Specification Guide
81
The initial steps of installation are as follows:
• Give the SCM an IP address
• Setup the root password
• Enable the boot image
• Set date and time
At Choose an option: Type “1” and press Enter.
Enter the IP address for the board <192.168.4.41> : Type the IP
address in the xxx.xxx.xxx.xxx format and press Enter.
Enter the Subnet Mask <<NULL>>: Type the subnet mask in the
xxx.xxx.xxx.xxx format and press <CR>.
Enter the Default Gateway <<NULL>>: Type the default gateway in the
xxx.xxx.xxx.xxx format and press <CR>.
After this, the initial screen will display again.
Choose an option: Type “2” and press <CR>.
Enter the ROOT password <MIN:6 MAX:12>: Type your password ********
and press <CR>.
Re-Enter the ROOT password <MIN:6 MAX:12>: Type your password again
******** and press <CR>.
The initial screen will appear again.
Choose an option: Type one of the following “5, 6, 7 or 8” and press <CR>;
or leave the default in place.
If you typed “6”, the following will appear:
Enter the TFTP server IP address <192.168.4.43>: Type the IP
address in the xxx.xxx.xxx.xxx format and press <CR>.
Enter the TFTP file Name <max: max 128 chars> </tftpboot/lat-
est/mediapiPlex-image>:
Type in a new path for the boot image or press
<CR> to accept the default.
If you have a PMCIA disk in the SCM, you can boot from that image. If you
choose an option that does not exist, the initial screen will return. To choose
option 7 or 8, the SCM will boot from the internal flash boot image.
NOTE
The IP address in brackets shows the last IP address entered. Also
Enter is shown as <CR>.
NOTE
To accept the IP address in brackets just press Enter.