S0740 800 152/E061012/P36
-- 2 6 --
ci01i_ma6u6b
MIG/MAG WELDING
Settings for MIG/MAG welding without pulsing
Settings Setting range In steps of Default setting
2/4--stroke
1)
2--stroke or 4--stroke -- 2-- stroke
Crater filling OFF or ON -- OFF
Crater fill time 0--5s 0.1 s 1.0 s
Hot start OFF or ON -- OFF
Hot start time 0--10s 0.1 s 1.5 s
Creep start OFF or ON -- ON
Gas purging
1)
-- -- --
Cold wire feed -- -- --
Synergy OFF or ON -- ON
2)
Inductance 0 -- 100 1 70
Gas pre-- flow 0.1 -- 25 s 0.1 s 0.1 s
Burnback time 0--0.35s 0.01 s 0.10 s
Gas post--flow 0.1 -- 20 s 1s 1s
Spot welding OFF or ON -- OFF
Spot welding time 0.1 -- 25 s 0.1 s 0.1 s
Voltage 8--60 0.25 (displayed with
one decimal)
synergy deviation
¦ 0
Wire feed speed* 0.8 -- 25.0 m/min 0.1 m/min 5m/min
T rigger data OFF,
ON or
ARC OFF
-- OFF
Dimensions METRIC or INCH -- METRIC
Panel enable OFF or ON -- OFF
Automatic save
3)
OFF or ON -- OFF
AVC feeder
3)
OFF or ON -- OFF
Limits
3)
OFF or ON -- OFF
Lock code
3)
OFF or ON -- OFF
1)
These functions cannot be changed while welding is in progress.
2)
The synergy line on delivery: solid wire (Fe), shielding gas CO
2
with wire 0.8 mm.
3)
Contact an authorised ESAB service engineer to activate this function.
To Next Page
Loading...
