S0740 800 152/E061012/P36
-- 3 4 --
ci01i_ma6u6c
Settings
Panel enable
When a remote control unit is connected it is possible to set current or voltage and wire feed
speed by the control panel or the remote control unit.
Note: this function must be activated before the remote control unit is connected.
-- Activation of panel enable performed in the configuration menu.
Auto save
If a welding data setting is recalled from the welding data memory and the settings are
adjusted, the changed settings will automatic be saved when a new welding data setting is
recalled from the memory.
Contact a n authorised ESAB service engineer to activate this function.
-- Activation of auto save performe d in the configuration menu.
Limits
By this function max. and min. values for wirefeed / current or voltage can b e set. The limits
can be saved in the first 5 memory positions of the welding data memory.
Contact a n authorised ESAB service engineer to activate this function.
-- Activation of limits performed in the configuration menu.
Lock code
By this function the settings menu can be locked, then it is only possible to select the main
menu and the measurements menu, see chapter “Lock code”.
Contact a n authorised ESAB service engineer to activate this function.
-- Activation of lock code performed in the configuration menu.
MEMORY MANAGEMENT
Various welding data created in the primary memory can be stored in the memory menu. Up
to 10 different weldin g data settings can be stored.
LOCK CODE
Contact a n authorised ESAB service engineer to activate the lock code.
S Press
to access the lock code menu.
S Press
until the first digit of the PIN code is
selected.
To Next Page
Loading...
