User’s Guide User programming: An introduction
C.4
3 Station options
The station options sub-menu (PROG/HELP 3) lets you activate or deactivate several features your station
can provide. At each option sub-menu, 1 enables the option and 0 disables it. (Each option listed below is
explained elsewhere in this manual, as noted.)
1 Call waiting/background announce
See page E.13 for call waiting and page E.13 for background announce.
Note: Background announce is not available on a legacy 12-Key Feature Phone.
2 Personal greeting reminder
See page F.10.
3 [Unused]
4 Outside dial tone preference
See page F.13.
5 Hands-free answer
Note: With an ESI Cordless Handset, use of this feature requires a headset.
See page E.3.
Note: Not available on a legacy 12-Key Feature Phone.
6 Message monitor
See page F.10.
Note: Not available on a legacy 12-Key Feature Phone.
7 Power-saving mode
Note: Applicable to only an ESI Cordless Handset.
Allows you to enable or disable an ESI Cordless Handset’s power-saving mode. Enabling this mode helps
achieve full battery life. However, if full-time status monitoring is required, you can disable this mode. In
power-saving mode, the phone system blocks all status updates
1
to the Cordless Handset when the
Handset has been idle for 30 seconds. Pressing the Cordless Handset’s keys or receiving an incoming call
on it will discontinue power-saving mode.
Note: When the handset has received no calls or status updates
1
for five minutes, the Cordless Handset
enters deep-sleep mode. During it, the display is blank and the LEDs don’t light up. If the system
sends any updates to the Cordless Handset, it will discontinue deep-sleep mode.
1
For example: If you have a programmable feature key set as a station key for someone’s extension, the system updates your Cordless Handset
based on that extension’s current status (busy, idle, do-not-disturb, or — with optional ESI Presence Management — off-premises).
To Next Page
Loading...
