EasyManua.ls Logo

ESI ESI-50 - Basic Phone Usage

ESI ESI-50
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User’s Guide ESI phone operation
E.5
Basic phone use
Outside calls
To answer (double-ring cadence): Lift the handset or press SPEAKER. If using a Cordless Handset, either
press TALK or remove the Cordless Handset from its charging cradle.
To place: Lift the handset or press SPEAKER. Then either press an unlit line key or dial 9 (or 8 or 71–76)
1
to
be assigned an outside dial tone. On a Cordless Handset, press TALK and dial 9 (or 8 or 71–76).
1
To hang up: Replace the handset or press RELEASE or — if using the speakerphone — press SPEAKER.
If using a Cordless Handset, press TALK or put the Handset in its charging cradle.
Important: If you’re using a VoIP-enabled system, be aware that your outside phone lines’ quality can affect the
audio quality of local and remote IP phone(s). Due to the interface between advanced, packet-based
phone systems and the traditional public telephone network, a poor-quality phone line can degrade audio
quality, causing an echo on outside calls. An occasional echo isn’t unusual and doesn’t necessarily
indicate a problem with your system or lines; however, if this problem occurs persistently, contact your
Certified ESI Reseller for assistance.
Internal calls
To answer (single-ring cadence): In hands-free mode, answer directly through the speakerphone or pick
up the handset. Or, to answer a ringing call, lift the handset or press SPEAKER. If using a Cordless Handset,
either press TALK or remove the Cordless Handset from its charging cradle. (To receive a “hands-free-
answer” call on a Cordless Handset, you must be using a headset.)
To place: Lift the handset and dial the extension number or press a station key (see “Direct station selection,”
page E.6). On a Cordless Handset, press TALK or dial the extension.
To hang up: Replace the handset or press RELEASE or press the station key again or — if using the
speakerphone — press SPEAKER. If using a Cordless Handset, press TALK or put the Handset in its
charging cradle.
Shortcut for either outside or internal calls on speakerphone-equipped ESI phones:
If you press a station key or dial an extension number, the phone system automatically activates
the speakerphone.
1
What you dial to reach an outside line depends on your system’s particular setup. If you’re not sure, consult your administrator.

Table of Contents

Other manuals for ESI ESI-50

Related product manuals