IVX 20 Hardware overview/installation
B.5
Hardware installation
Site location
As with most electronic equipment, the environmental considerations for this site need to observe
good common sense. Provide a dry, clean, and accessible area.
Locate within the telephone equipment room a space which will provide easy connection to the 66
blocks and 110 VAC power. The location should be no further than 1,000 feet from the furthest
station.
Note: Ambient room temperature must be between 40°F and 80°F.
Note: Do not place the equipment or station runs near high voltage electrical equipment or electri-
cal lines susceptible to high voltage surges from air conditioner compressors, etc.
The system and supporting components should be mounted to a one-half-inch or greater plywood
backboard. A typical installation layout is shown below.
To Next Page
Loading...
