ESI IVX20 - Page 26

System programming: an introduction IVX 20
C.4
System programming overview
1 System parameters
11 Initialize
12 Installer password
13 Administrator password
14 Set time/date
15 System timing parameters
151 Flash duration
152 Transfer recall timer
153 Hold recall timer
16 Recording alert tone
17 System speed dial
2 CO line programming
21 Line programming
22 Toll restriction programming
221 Centrex/PBX access code
222 Toll restriction exception tables
23 Line parameters
231 Line receive volume
232 Line open-loop Interval
24 Caller ID programming
3 Extension programming
31 Extension definition and routing
32 Extension feature authorization
33 Department groups
35 Extension button mapping
4 Auto attendant programming
41 Auto attendant branch programming
43 Automatic day/night mode table
5 Voice mail programming
53 Guest mailboxes
55 Message notification options
6 Recording
61 Record Main Greeting
62 Record directory names
63 MOH programming
631 MOH source
633 MOH volume
Entering Installer programming mode
Programming can be done from any Digital Feature Phone in the system. To enter
programming mode:
1.
Press PROG/HELP. The normal station programming menu prompt will begin to play.
2.
Press PARK to stop the prompt.
3.
Enter the Installer password, followed by #.
4.
Follow the system programming menu.
5.
When finished, hang up.
Note: While in programming mode, the extension will be automatically placed in DND.
Note: The system will automatically exit programming mode after 10 minutes of inactivity.
Example: To enter programming mode, press PROG/HELP, PARK, 7 8 9 [or new Installer
password], #.
To exit programming mode, hang up.