Essen BioScience IncuCyte ZOOM - Verifying the Incucyte Controller Network Connection: Windows Vista or Windows 7; Verifying the Incucyte Controller Network Connection: Windows XP

Page 19
To verify that the ZOOMXXXXX controller has been successfully added to the network, a
Windows-based PC (hereby referred to as the “PC”) on the same network is required. These
verification methods are discussed separately for Windows Vista/7 and Windows XP PC’s.
4.1.1 Verifying the IncuCyte™ Controller Network Connection: Windows Vista or
Windows 7
1. Under the Windows “Start” menu, select “Network” (Vista) or “Computer”
(Windows 7).
a. Windows 7 only: On the left side of the window there is a list of
destinations (“Favorites”, “Libraries”, etc.). Look for the “Network”
destination and select this by left-clicking.
2. Look for the computer named ZOOMXXXXX (recall that XXXXX is the 5-digit
controller serial number). If you find it in the window, then the controller was
successfully added to the network, and you are done. If not, you should attempt to
find the controller on the network by continuing to the next step.
3. At the top of the window there is a text area that reads “► Network ►”. Left-click
in an empty area to the right of this text and type the following: \\ZOOMXXXXX
followed by the “Enter” key.
4. If the controller is found on the network, you will be prompted for a User name
and password. Press the “Cancel” button to exit. If the controller is not found,
then a “Cannot Find” message will be displayed after a brief search period.
4.1.2 Verifying the IncuCyte™ Controller Network Connection: Windows XP
1. Open “My Computer” from the PC’s Windows Start menu.
2. Under the heading “Other Places” on the left side of the window, open “My
Network Places.”
3. Under the heading “Network Tasks” on the left side of the window, click once on
“View workgroup computers.”
4. Look for the computer named ZOOMXXXXX (recall that XXXXX is the 5-digit
controller serial number). If you find it in the window, then the controller was
successfully added to the network, and you are done. If not, you should attempt to
find the controller on the network by continuing to the next step.
5. Verify that the “Address” toolbar is displayed at the top of the window. Under the
“View” menu time at the top of the window, verify that the “Toolbars - > Address
Bar” menu item has a check mark next to it.
6. Type the following in the “Address” box at the top of the window: \\ZOOMXXXXX.